Frontpage

We Quadriplegics (Teddys) Love Tootpaste Tubes!

Every morning starts with the spirited bite into the screw cap.

As long as the tube is still full you can manage to get something out most of the time, even without finger function. However, at some point you don’t need coffee anymore for breakfast because proportional to the decreasing amount of toothpaste left in the tube the blood pressure rises.

You all know those plastic clips for sealing bags (see older post).a>

Now with this clip I can get a pretty good grip of the tube.

After removing the screw cap from the tube place it on the sink and squeeze it with one hand.

No need to empty the tube at once .

Translator BW

Wie HOW DO I (WITHOUT FINGER FUNCTION) PREVENT MY SMART PHONE FROM FALLING DOWN?

I never go anywhere without my smart phone, not even in my own apartment.

What could really happen there?

t happened a few years ago in my office that I rolled over a 220 Volt extension cord and got caught in it. The cable got wrapped around the wheels and I could not move forth or back. I was only a few centimeters away from both my phones, mobile and landline. I felt like a ship that ran aground! It took me about 2 hours to free myself. Waiting for the “flood” might have helped I.
Since I am not able to pick up a phone from the floor I should certainly avoid letting it fall.

When sitting in my wheelchair I always have a smart phone on a key chain around my neck. A few times I did have to dial 911.

We punched two holes in the cell phone case, one to attach the key chain and the other one to insert my index finger for support because I cannot entirely hold the phone on my own.

You all know those smart phone pockets, the ones that joggers wrap around their upper arms.

Take such a pouch and shorten the sling so it fits around your forearm.

Now you can operate your smart phone with the other hand without the risk of it falling to the floor.

Translator BW

remote-controlled electrical sockets

as useful technical aid. I am using these things for years to switch my

Christmas Tree lighting

on and off. Since a couple of weeks my living room lamp gets switched on by a ghostly hand. I think it’s quite funny, a neighbour is probably using the same frequency!

Translator BL

Noodle Strainer Hybrid

As I mentioned several times in the past, the function of my hands and fingers equal those of a four-year old armed with gloves in winter.
Since half a sandwich roll, plain without anything on it, already feels like a 5 kg weight to me, daily exercise of the hands and fingers is a must.
I have already tried various hand training tools. The classic soft rubber ball has the disadvantage that because of Isaac Newton it constantly falls to the ground if you spread or stretch your fingers.
More than eight years later I discovered this ingenious hand trainer, also known as a “noodle strainer”. About the expert use of such a devise I shall report in a later blog .

You put your fingers somewhat narrow or wider apart in the fitting holes. Since the inside ring is made of rubber you can quite simply perform hand curls- and stretches. With a slight twist of your arm it is also suitable for upper arm and wrist strength training.
If you want to make sure that the hand trainer does not fall down, simply attach a key band to two holes.
The hand trainer has no aid number and is considered sports equipment which explains the price of currently €29.95 plus shipping. It is available in various strengths levels at Sport-Thieme under Art.-No. 2194224.
To the link: click here

For Tetras like me, who still have some finger functions and people who have severe osteoarthritis this hand trainer is highly recommended, especially because it can be used comfortably while watching TV – no thinking required.

Excessive consumption of pasta might have a positive impact on the aerodynamics of a Rolli, but not so much on its axle load.

To read all articles of the “Tips on Aid Series”, click here.
At the end of the page simply go to: “OLDER ENTRIES”

Translator BW

It is due to the small fouls that wheelers are exposed every day to new challenges. You are blocked in from the side so that you can’t get into your car anymore, during cleaning the toaster is moved back to the wall, or the installation CD is put out of reach on the cupboard. My last week’s highlight was a beeping smoke alarm because the battery was empty when I was lying in my bed. All this is causing an uncontrollable neuron tornado in my head.

Among my favourites are open windows.

In the summer it’s getting warm and in winter quite cold, if the heater below is not running on full power which I can’t reach either.

There are definitely more important reasons to ring at the neighbour’s door than asking them to close an open window. Grrrrrrrrr…

The do-it-yourself store with 20% on everything except for the parts you really need offers a

Hobbit &wheelchair window closer/

„almost“ usable in their assortment. However, small construction work needs still to be done.

Just take:

• min. 1 meter aluminium pipe, thickness 12mm
• 1 meter aluminium flat bar 15m x 1mm
• 30 cm hose inner diameter 10mm- 12mm
• 2x screw M4 x 25mm
• 2x screw-nut, self-locking M4
• 1x drill 4 mm with drive mechanism
• Construction tools for screwing, or a set of healthy teeth

Cost of material ca. 10,00€

Saw the aluminium bar in ca. 2x 36 cm long pieces and pull the hose on one of the pieces.

Drill a 4 mm hole into all sides of the aluminium bars and the pipe centered with a space of 15 mm from the edge.

Bend the aluminium bar with hose oval e.g. using a bottle and bolt it two-sided with screw and screw-nut on one end of the pipe. This is going to be the window side.

The other aluminium bar is going to be the handle. This can be formed according to hand function or artistic freedom oval, square, round or even heart-shaped, main thing is that the bolting on the pipe is not forgotten.

(My white Vespa scooter from 1992 in the picture below with kick starter is looking for a new master!)

The operating mode of the window closer should be comprehensible, but could on special request be explained personally under phone number 00907/40059449665 for only (1.000.000.000 €/min) by “Bernd das Brot”. (Translator’s note: Reference is made to a satirical sketch to spoof call-in shows on TV, (see also other blogpost).)

All open windows can be closed again now.

And how to open them we will learn tomorrow!!!

The certified re-constructor is obligated to send to the Rollinator a Chilli Pizza online.

Contact: rollinator@eigude.de

Translator BL

Rollinator (Wheelinator)-Smartphone-Charging-Plug-Clip

Ever since I joined the folks on wheels, I carry my mobile phone/smartphone on a lanyard close to my heart ; -)

In the rare event that some cable gets wrapped around the rear wheel of the Wheelchair and therefore vehemently denies me to continue my ride, at least then should there be a phone in range.
I don’t think I need to elaborate about the extremely modest battery life of smart phones. Of course, the battery should always be full when out in the wild.

With my crooked fingers it takes me an estimated three minutes daily to stick the Micro USB charger in to the phone to be charged. I just realized that in the last three years I have rendered two full days of my life to my cell phone plug… just great!

The easiest solution to counter this waste of my time appeared to be in the purchase of a cradle charger. Unfortunately, it was not compatible with the leather cover of my phone.
A few years ago I built a holding device for the TV Magazine with just a small metal paper clip. This gave me the idea (see older post).

The perfect size to hold the Micro USB Plug is 20mm x 10mm x 8mm (0.8“ x 0.4” x 0.3”)

Attach a small cable tie and you practically get to plug it in without any finger function and daily blood pressure increase.

The paper clips (binder clips) can be found on the internet, in the stationery shop or after several days of searching maybe in one of your clutter trays.

For other tips on the subject of “tools for restricted finger and hand movement” like me, click here.

Translator BW

I like my smartphone…!!!

With my old mobile phone I didn’t write as much as 5 text messages within 5 years since my accident because I couldn’t push the small buttons with my buckled thumb.

When I tried to hit the keys with my index finger it looked a bit like our fellow citizens who were born before 1965

I would like to point out here that you can not learn to be patient!!!

You might be able to say: You can learn to endure patience, but nothing more.

For someone like me with my tired fingers a smartphone is really brilliant. A little sweep over it, and the text message is almost done.

The search for my first smartphone was a little difficult.

Many things which I buy I pick because of handling and key chain suitability so that they don’t fall down immediately.

I am “Lord of the key chains”, see older blogpost.

(Picture is not faked!!!)

Newton, you know who I mean, the guy with the apple, has fallen in disgrace already for years.

When I searched for a “Rollinator-Tetra-suitable Smartphone” I noticed that these phones compared to a regular cell phone don’t have a loop any more to hang them on one of my beloved key chains.

The sales clerk suggested fastening a key chain to the slots of the speaker on the cover…

This won’t last for 2 minutes with me!!!

The chance of survival for a smartphone without Rollinator-fall protection is highly estimated below 5 days.

Before I had a Samsung offroad cellphone, with a giant loop and extremely robust, but with no special functionalities.

Thus I bought the Samsung S3 offroad smartphone, but brought it back after a weekend of installation work because it constantly crashed…!!! For once, I don’t mean the device, but the software. Additionally the internal memory of 100 MB was just enough for 25 apps, ridiculous…

So better the regular S3 (by now I knew the handling), but with a solid leather or silicone cover and key chain. There should be some suitable accessories available for me..

Even after days of extensive search in stores and internet I couldn’t find a cover on which I could hang a key chain!!!

Would the producers want the phones to regularly fall down???

So I had to help myself…!!!

The solution was so simple… I bought a standard leather cover and punched my key chain hole into it myself with my office hole puncher.

Smartphone with self-made fall protection

Please note the display: Model 386 SX 12MHz

There is actually a smartphone cover with key chain loop available, see below…!!!
There is actually a smartphone cover from Samsung available, thanks to Mark for the tipp:
The cover is an original Samsung accessory, the loop is quite good, and because of the rubber cover it doesn’t slip away easily…
Without cover it was regularly lying on the floor, and I thought it was a pity that the loop for the key chain was missing… I bought it here:

http://www.amazon.de/gp/product/B0083TWHFG/ref=oh_details_o02_s00_i00?ie=UTF8&psc=1

It is available in different colours… Important it is original Samsung… The “no names” don’t really fit tight to the phone.

Translator BL